Andersen 3SNEZR36BL Guía de instalación descargar pdf (Pagina 5)

5

RIGHT HANDED - EXTERIOR VIEWSLEFT HANDED - EXTERIOR VIEWS

Tools needed:

In this step, you will remove and discard

all orange installation clips.

Grasp handle clip and pull away from

latch rail to remove. (Figure 13)

Fill holes in latch rail with color

matched plugs. (Figure 14)

TIP: Use a screw driver to loosen

and tighten screws in Steps 3 and 4;

a drill may strip the screw holes. If

screws do strip, replace with #10 x

1/2” screws included in the closer kit

Remove spacer clips by loosening,

but not removing screws, then

remove clip. (Figure 15)

Re-tighten screws.

Remove bottom spacer by pressing

down on raised lip. (Figure 16)

Properly discard all orange clips.

Starting at the mitered corners,

remove the clear protective tape

from both the interior and exterior of

the door frame, if applicable.

1.

2.

3.

4.

5.

6.

7.

4. REMOVE INSTALLATION CLIPS AND PROTECTIVE FILM

Figure 13

Figure 16

Figure 15

5

6

1

1

7

3

Figure 14

Figure 13

Figure 16

Figure 15

Figure 14

5

6

1

3

1

7

1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios