Andersen 3SNEZR36BL Guía de instalación Pagina 3

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 11
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 2
3
2. INSTALLATION PREPARATION:
In this step, you will con rm your storm door hinges on the
correct side.
Con rm your storm door hinges correctly by using your
measurements from step 1 and comparing your door to
gures 5 and 6.
Position the door on a protected surface so the exterior side
of the door is facing up.
TIP: Lay on door carton
Starting at the mitered corners, remove clear protective tape
from bottom of door, and the bottom 3” of the door sides.
Place decorative trim plate onto the door and align edge
of decorative trim plate with latch side edge of door frame.
(Figure 7)
Fasten decorative trim plate to door frame using three #8 x
1/2” self drilling screws. (included in closer kit)
Remove door from carton, grasping the door as shown
NOTE: when lifting the door, support the weight of the door
by the door frame, not the hinge and latch rails.
With door standing, ensure latch rail is properly seated in
the orange spacer clips (Figure 8B), and ensure bottom
spacer is attached to the bottom of the door and is slid to
the handle side. (Figure 8A)
NOTE: See troubleshooting section at the end of the install
guide if bottom spacer becomes detached from the door
frame.
1.
2.
3.
4.
5.
6.
7.
RIGHT HANDED
LEFT HANDED
EXTERIOR
VIEWS
Figure 5
Figure 6
Tools needed:
3 - #8x1/2”
If your door came with a decorative trim plate, you will attach it
to the exterior of your door in this step.
NOTE: Some models include an optional decorative trim plate
for the bottom exterior of the door. If your door includes this
decorative trim plate and you wish to attach it, complete steps
2-5 below. If not, skip to step 6.
In this step, you will ensure all clips are properly attached to the
door and mounting componets
Figure 8
Figure 8B
Figure 8A
Grasp Here
Figure 7
12
1
Vista de pagina 2
1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios