Andersen 3SNEZR36BL Guía de instalación descargar pdf (Pagina 4)

4

RIGHT HANDED - EXTERIOR VIEW

LEFT HANDED - EXTERIOR VIEW

3. HANG HINGED STORM DOOR

Tools needed:

In this step, you will place the door

in the opening and fasten it to the

mounting surface.

Set bottom of door into opening,

centering it in the opening. Ensure

orange bottom spacer is sitting on

door sill. (Figure 9)

Tip the top of the door into the

opening while ensuring the bottom

of the door frame rests on the

orange spacer. (Figure 9).

TIP: Place foot against door bottom

while tipping the top of the door

frame assembly into the opening.

The door frame assembly is properly

seated in the opening when both

the latch rail and hinge rail are ﬂ ush

against the mounting surface and

the hinge z-bar and bottom spacer

(highlighted in yellow) are resting on

the door sill. (Figure 10)

NOTE: The gap between the top

of the door and the raincap is

intentionally uneven at this step.

The gap will become even in later

steps.

While holding door in position,

use the 1/8” drill bit (included in

the closer kit) to drill a hole in the

mounting surface through pre-drilled

holes marked “A” and “B” in ﬁ gure

10.

Fasten the door to the mounting

surface using two #8 x 1 screws

(Figure 10).

Pre-drill holes in the mounting

surface through the remaining ten

pre-drilled holes in the side rails.

Fasten the door to the mounting

surface using ten #8 x 1 screws.

Remove two handle hole fasteners

by inserting a phillips screwdriver

into the handle hole and ﬁ rmly

pressing them out. (Figure 11)

Properly discard orange handle

fasteners.

Grasp the edge of the door and

ﬁ rmly pull the door open

NOTE: DO NOT OPEN DOOR

BY PULLING ON THE HANDLE

HOLES, INJURY COULD RESULT.

Using the 1/8” drill bit, drill holes in

the door jamb through the holes in

the hinge rail.

Fasten the hinge rail to the door

jamb using eight #8 x 1 screws

(Figure 12). Do not overtighten the

screws.

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

20 - #8x1”

1/8”

1/8”

Figure 9

Figure 10

A

B

Figure 9

A

Figure 10

Figure 11

Figure 12

Figure 11

Figure 12

1

1

1

1

7

1

7

14

B

1

1

1

14

1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios