Andersen HD20V36WH Guía de instalación

1for Andersen® 1-1/4” Fullview Storm DoorsInstallation GuidePlease Do Not Return Product to Store!EMCO Enterprises, Inc. PO Box 853 Des Moines, IA 50

10PRODUCT LIMITED WARRANTYDOOR FRAME: EMCO Enterprises, Inc. (EMCO) warrants the door frame, hinges, and painted finish on Andersen® aluminum storm do

2Improper use of hand or power tools could result in injury and/or product damage. Follow equipment manufacturer’s instructions for safe operation. A

32. INSTALLATION PREPARATION:Figure 7Figure 8EXTERIOR VIEWSIn this step, you will remove the insect screen and shipping clip.Lay the door at on a pr

4LEFT hINGE - ExTERIOR VIEW (FIGURE 9) RIGhT hINGE - ExTERIOR VIEW (FIGURE 9)3. PREPARE STORM DOOR FOR hANGINGIn this step, you will hang the rain ca

5LEFT hINGE - ExTERIOR VIEWS RIGhT hINGE - ExTERIOR VIEWS14 - #8x1”1/8”Tools needed:In this step, you will hang the storm door in the opening.Position

68 - #8x1”1/8”Tools needed:In this step, you will nish fastening the rain cap to the top mounting surface.Close the storm door.Adjust the rain cap so

7Tools needed:7. INSTALL SCREW COVERSLEFT hINGE - ExTERIOR VIEWSIn this step, you will install the screw covers over the mounting screws in the rails

88. INSTALL WEAThER SEALING COMPONENTS2 - #8x1/2”INTERIOR FLOORIn this step, you will install the bottom sweep components.Slide the sweep n into the

99. INSTALL CLOSERTools needed:5/32”4 - #10x2”2 - #12x5/8”In this step, you will install a jamb bracket onto the door jamb at the bottom (Figure 26).